| |
 |
 |
 |
|
Screw and CS Washer |
July 31, 2020 |
| Reviewer:
Bryan
|
|
I was surprised at the setup of using a thick-head 5mm metric screw and a matching countersink washer. Is this a normal E Germany side-folding stock setup? Not sure! I'm goin to put this screw/washer combination to the test! I'm going to remount my factory Polish Tantal Wz88 wire side-folding stock using these screws with a lil' threadlocker to boot. They should work fine for anchoring the stock without the dreaded loosening of the stock while shooting! Thanks and remember to support the 2nd Ammendment.
Was this review helpful to you? 
|
|
 |
|
 |
|